ASSEMBLY
1. Press handle assembly button while inserting the handle into the handle opening on
the main body making sure not to pinch internal cord. Handle assembly button will
snap into place when handle is fully connected. (Fig. 1)
2. Attach the power nozzle into the air intake of the main body making sure contacts
between the nozzle and body are aligned and inserted completely. (Fig. 2)
CHARGING
NOTE: Use only the charger supplied by the manufacturer to recharge.
IMPORTANT: Before rst use, charge your vacuum for at least 24 hours.
Both power switches must be in the OFF position when unit is charging on base. If
charging light is not illuminated, press ON/OFF button to assure unit is turned off.
Remember, unit will not charge if charging light is not illuminated.
CAUTION: Do not allow the battery to run down completely before charging. Running
down battery will cause battery life to shorten severely.
1. Connect charger into the charging port located on the side of the vacuum
(in the hand vac). (Fig. 3) Charge unit with hand vac stored on-board.
2. Connect wall charger to the outlet.
3. A red charging light will illuminate when unit is charging. Unit will be charged in
16-24 hours. Recharge unit as soon as the motor power decreases noticeably. The
unit can be on a constant charge so it is always ready for use.
4. The light stays on and remains the same color even when the unit is fully charged.
DIRECTIONS FOR USE
NOTE: Be sure hand vac is properly stored
on-board before using stick vac.
1. Slide the Selector switch to either FLOOR
(suction only/brushroll off) or CARPET
(suction with brushroll on). (Fig. 4)
2. Use complete stick vac to remove dust and debris from bareoors and carpets.
3. Tools can be inserted at bottom of stick vac by removing nozzle base and inserting
tool into opening. Ideal for hard-to-reach, above oor cleaning.
STICK VAC
Fig. 4
Fig. 1 Fig. 2
Fig. 3
Fig. 5
Fig. 6 Fig. 7
1. Press two side HAND VAC RELEASE buttons and pull the hand
vac from the main unit. (Fig. 5)
2. Turn power switch ON.
3. Use for above oor cleaning such as counters, upholstery etc.
4. Insert crevice tool/dust brush into the opening of nozzle to extend
reach. (Fig. 6)
5. To replace the handheld unit, insert the dirt cup into the main body rst then
press the upper portion of the hand vac into the main body until it’s secure. (Fig. 7)
6. Empty and clean dirt cup and lter after each use or when cup is full.
HAND VAC
E-4
E-5
(12 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals