Guardian Technologies , LLC Home Security System DVST User Manual download pdf (Page 46)

8.4 ASCOM 5000 / CITAM

ATMODE

Cables required - 2x 15 to 15 (Part No. AS-DVST-X21). Dip switch settings can be used

and should be set as follows:

Note: Switch 3 selects the sub address, if used.

Step Instruction Remarks

1 Using the pull handle, remove the

circuit board module from the Citam

5000

2 Adjust the dip switches as shown in

Figure 9

The Citam will now perform a self test.

On completion the display will read

ISDN.

3 Press the select key four times so

that the legend ‘CONF’ appears on

the display.

4 Press the enter key once and it will

say ‘PRT1’, press the select key

twice it will say ‘TA’, press the enter

key it will say ‘SHOW’.

5 Press and hold select until the

display reads ‘CHNG’, remove your

finger from the select key and press

the enter key, ‘INDB’ will be

displayed.

6 Press the enter key, the message will

be ‘ON’, use the select key to turn

this to ‘OFF’, then press the enter

key.

7 Hold the select key and press the

enter key, the display will return to

‘CONF’.

This has turned of the in-band test

feature of the unit.

At ‘CONF’ press the enter key, the

display will read ‘PRT1’ for port 1.

Page 34 Dedicated Micros Ltd

Terminal Adapters DVST Installation Guide

Fig 5: ASCOM internal dip switch settings (ATMODE)

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 79 80

No comments

Guardian Technologies , LLC Home Security System DVST User Manual Page 46