Guardian Technologies , LLC Home Security System DVST User Manual download pdf (Page 48)

AT&W<RET>

<ESC>

QUIT <RET>

These commands are entered using

Setup Mode on the DVST0200 unit via

a PC. Refer to Chapter para

The Citam is configured to operate on DVST.

X21

Cables required - 2x15 to 15 (Part No. AS-DVST-X21)

Dip switch settings can be used and should be set as follows:

Note: Switch 3 selects the sub address, if used

Step Instruction Remarks

1 Using the pull handle, remove the

circuit board module from the Citam

500

2 Adjust the dip switches as shown in

Figure 10

The Citam will nowperform a self test

On completion the dispaly will read

ISDN

3 Press the select key four times so

that the legend ‘CONF’ appears on

the display

4 Press the enter key once and it will

say ‘PRT1’, press the select key

twice it will say ‘TA’, press the enter

key it will say ‘SHOW’

5 Press the hold select until the display

reads ‘CHNG’ remove your finger

from the select key and press the

enter key, ‘INDB’ will be displayed

6 Press theenter key, themessage will

be ‘ON’,use the select key to turn this

to ‘OFF’, then press the enter key

7 Hold the select key and press the

enter key, the display will return to

‘CONF’

This has turned off the in-band test

feature of the unit

At ‘CONF’ press the enter key, the

display will read ‘PRT1’ for port 1

Page 36 Dedicated Micros Ltd

Terminal Adapters DVST Installation Guide

Fig 6: ASCOM internal dip switch settings (X21)

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 79 80

Comments to this Manuals

No comments

Guardian Technologies , LLC Home Security System DVST User Manual Page 48

Comments to this Manuals